Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
1. Now slowly open the old radiator valve. Place a
suitable bowl under the valve or have several cloths
ready to collect the escaping water.
2. Unscrew the old valve. This will allow a small
amount of water to escape again.
3. Now fit the automatic radiator air vent with a 19 mm
open-end wrench. Then open the flow and stop
valves again.
4. Turn the knurled screw counter-clockwise by
approx. 1 – 2 turns to vent the radiator.
5. When water comes out, tighten the knurled screw
again. The automatic radiator air vent now vents
automatically.
Remember that water may leak when venting. Al-
ways place a suitable bowl under the radiator and
turn the outlet opening (white adjusting ring on the
valve) in the direction of the bowl.
Hints:
▪ Only use a wrench to install the automatic radiator
air vent at the highest point of the radiator. Do not
use a screwdriver or similar for mounting.
▪ The radiator air vent is self-sealing, you do not
need hemp, Teflon tape, etc. for sealing.
▪ When tightening the knurled screw, take care not to
overtighten the thread.
Werbung
