Grundig MDI907 Gebrauchsanweisung Seite 13

Use of the unit
Measuring procedure
As a object thermometer
1. Select Object Mode, the temperature unit will
appear. (Picture at right)
2. Move the probe close to the object, make sure
the probe is flat and take measurement with
a distance within 1-5cm. Press the Start/Stop
button to take measurement
3. The measurement will be finished in 1 seconds,
when it has been completed, you can hear 3
short beeps, at the same time, the reading will
appear on the display
Note :
• As the object scan temperature is likely to be
affected by the surroundings, the reading shall
be taken as a reference only.
• If the probe is placed at an angle close the object scan, the
reading will be affected by surrounding temperature.
• The thermometer will automatically turn off if left idle for 30
seconds.
13