Meaning of light signals
Memo
Memo
Memo
Aroma plus
Espresso
Espresso lungo
Co ee
Hot water
Steam
Calc
clean
Caution: If the no water lights up continuously and the rinse cycle light
does not go out, the water tank was not filled up to the MAX level for the
rinsing cycle.Fill the water tank with fresh water and repeat the process
from step 10.
14 Remove the drip tray, rinse it and place it back. Empty the container.
15 Reinstall the Intenza+ water filter (if present).
16 Remove the water tank and rinse it.
17 Reattach the classic milk frother.
18 Clean the brew group by performing the 'Weekly brew group cleaning'
cycle.
The machine is ready for use.
Interruption of the descaling cycle
Once the descaling procedure has started, complete it until the very end
without switching off the machine. If the machine gets stuck during the
cycle, you can exit the descaling procedure by pressing the ON/OFF button.
If this occurs, or in case of a power failure or accidental disconnection of the
cord, perform the following steps:
1 Remove the water tank rinse it and fill it with fresh water up to the MAX
level.
2 Make sure the main switch is set to the ON position.
3 Press the ON/OFF button to switch on the machine.
4 Wait until the ESPRESSO, COFFEE, HOT WATER/STEAM buttons light up
continuously.
5 Empty the drip tray and place it back.
6 Empty the container and place it back.
7 Press the HOT WATER/STEAM button to dispense water. Press the same
button to stop the water dispensing.
8 Empty the container.
9 Place the container under the coffee dispensing spout.
10 Press the COFFEE button.
11 Repeat steps 9-10.
12 Empty the container.
If the CALC CLEAN button light remains on, you have to perform another
descaling cycle as soon as possible.
The machine is ready for use.
- The ESPRESSO and COFFEE buttons flash. The machine is warming up or
performing an automatic rinsing cycle.
English
23