Kärcher WRS 200 Handbuch Seite 23

 Please consult Kärcher-Service in the case of any un-
certainties or questions.
7 Fitting the adapter to the vehicle
The adapter with coupling triangle is attached to the rear of
the vehicle for mounting the WRS 200.
Adapter with coupling triangle
1
Bolts with spring pins (2x)
2
Screws (2x)
3
1. Push the adapter into the mounting frame of the vehicle,
observing the position of the various vehicles.
Figure: Installation on an MC 130 secured with a bolt and
spring pin
Adapter
1
Vehicle mounting frame
2
Position MIC 35/42 (platform C)
3
Position MC 130 (platform D)
4
Metal strip (2x)
5
Note
Required for installation on an MC 130
2. MIC 35/42: Push the adapter into position (1st or 2nd
hole) and secure on the left and right with a bolt and
spring pin.
3. MC 130: Fasten the metal strip at the bottom of the
adapter. Push the adapter as shown in the illustration
(3rd hole) and secure on the left and right with a bolt and
spring pin.
4. Tighten the screws to fasten the adapter firmly in place.
8 Attaching the top mount
The top mount stabilises the WRS 200 during operation
and transport. It must be attached to the WRS 200 once
only.
For the MIC 35/42 (platform C), mounting is performed be-
low the air holes.
For the MC 130 or MIC 50/70 (platform D), mounting is per-
formed above the air holes. The following description
shows the mounting for platform D.
The holes for attaching the mount are already present.
Unless specified otherwise, all nuts and screws are to be
tightened to the standard torque.
Mounting to the carrier vehicle is made via 2 upper links.
Mounting is described in a later chapter.
Top mount attachments
Reinforcement plate (2x)
1
Right-hand holder
2
Left holder
3
Upper links (2x)
4
Note
For mounting to the carrier vehicle
Screws M16x120 (2x)
5
Screws M16x100 (2x)
6
M16 stop nuts (4x)
7
18x200 washers (8x)
8
Mount fastening material
9
M8x30 screws (8x)
–
M8 nuts (8x)
–
8x200 washers (14x)
–
16x200 washers (8x)
10
Screw, washer, nut
11
For mounting the upper link on platform D
–
1. Check the scope of delivery.
Mount attachment for platform D (MC 130, MIC 50/70)
1
Mount attachment for platform C (MIC 35/42)
2
Reinforcement plate
3
Outer screw
4
Note
Install this screw without a washer
Upper mount cutout
5
2. Attach the reinforcement plate with mount on the WRS
200 (observe the correct mounting procedure according
to the platform).
English 23