Setting up
Switching on and off
Switching on:
♦
Press the safety lock-out
♦
Press the ON/OFF switch
chine is running, you can release the safety
lock-out
.
Switching off:
♦
Release the ON/OFF switch
Preselecting the rotation speed
♦
Set the required speed using the adjusting
wheel for speed preselection
1–2 = low speed
3–4 = average speed
5–7 = high speed
Setting the milling depth
♦
Make sure that the clamping lever
If it is released, turn it anticlockwise until it is
locked .
♦
Place the appliance onto the workpiece .
♦
Rotate the step stop
lowest position (0 mm) .
The depth stop
is now in line with the lowest
position (0 mm) .
♦
Undo the locking screw
♦
Release the clamping lever
clockwise and pushing the appliance down-
wards until the milling machine is touching the
surface of the workpiece .
♦
Lock the clamping lever
lockwise .
■
8
│
GB │ IE │ NI │ CY
and hold it down .
. Once the ma-
.
.
is locked .
until it engages in the
.
by turning it
by turning it antic-
♦
Slide the depth stop
reaches the lowest position (0 mm) of the step
stop
.
♦
Set the depth stop
depth, tighten the locking screw
♦
Now, release the clamping lever
the appliance again .
♦
Check the milling depth by means of a practical
test .
Re-adjusting the milling depth
♦
The milling depth can be readjusted using the
dial
.
♦
Release the clamping lever
clockwise and pushing the appliance down-
wards until the depth stop
is reached .
♦
Lock the clamping lever
lockwise .
♦
Set the milling depth with the dial
♦
Release the clamping lever
clockwise and raise the appliance again . Check
the milling depth by means of another practical
test .
Setting the milling depth with the
step stop
NOTE
►
The step stop
can be used for greater
milling depths in several stages with less chip
removal .
♦
Set the desired milling depth to the lowest step
(0 mm) of the step stop
ve) .
♦
Then set the higher levels for the first machining
steps .
♦
Check the milling depth by means of a practical
test .
downwards until it
to the desired milling
.
and raise
by turning it
on the step stop
by turning it antic-
.
by turning it
(as described abo-
POF 1200 D3