Connection Diagram - Velleman NVR2 Schnellanleitung

7. To install a second hard disk, find the supplied hard disk brackets in the package, and fix them to the NVR
base.
8. With the PCB side facing up, connect the hard disk to the power connector and data connector.
9. Place the hard disk in the brackets and fasten it with the supplied screws, two for each side.
10. Put the top cover back in place and fasten the screws.
7.

Connection Diagram

Note: To ensure that automatic configuration works well, connect and switch on the IP cameras first. Only then
switch on the NVR.
You can up to 12 IP cameras.
Refer to the illustrations on page 2 of this manual.
A IP camera
B Modem
C Router
D 8P8C (RJ45) network cable
Connecting the IP camera (plug and play)
1. Connect the camera to a hub/switch.
2. Wait until the camera is configured automatically and the images appear on the monitor.
8. Information and Panels on the Monitor
Refer to the illustrations on page 2 of this manual.
16 NVR status
key lock
channel lock
USB flash drive / device connected
timer recording on
overwrite on
sequence mode on
PTZ mode on
CPU load
V. 01 – 04/03/2013
NVR2
E monitor supporting high-definition video
F 19VDC power supply adapter
G NVR back panel
H hub/switch
key unlock
channel unlock
no USB device connected
timer recording off
overwrite off
sequence mode off
PTZ mode off
5 ©Velleman nv