Installing The Hard Disk Drive - Velleman NVR2 Schnellanleitung

offsite backup
 local and remote control completely independent
 HDMI video output resolution up to 1080P
 optional monitor: MONSCA8
adapter: PAC916T
HDMI cable: Professional or Premium
 optional hard disk: HD500GB/S, HD1TB/S, HD2TB/S
 USB mouse: included
 IR remote control: included
 IP cameras: suitable: CAMIP11, CAMIP12
 compatible with powerline adapter: EM8017, EM8024, EM8025, EM8026
 optional router: EM4542, EM4553, EM4570, PCRT1
5. Overview
Refer to the illustrations on page 2 of this manual.
Front panel
1
POWER
2
ALARM
3
WAN
4
LAN
5 SATA
6 HDD1/HDD2
7
USB port
8
mouse port
Back panel
9 RS485
10 SATA
HDMI video output
11
port
12 LAN
13 WAN
14 AUDIO OUT
15 DC 19V IN
6.

Installing the hard disk drive

1. Obtain a suitable hard disk (not included), type ESATA (Serial Advanced Technology Attachment). The hard
disk must be formatted.
2. Make sure to unplug the device from the mains before servicing and do not touch any electronic circuitry
to avoid electrostatic discharge.
3. Loosen the screws and remove the top cover.
4. Find the hard disk bracket in the NVR, and insert the hard disk in the bracket.
5. With the PCB side facing up, connect the hard disk to the power connector and the data connector.
6. Fasten the hard disk with the supplied screws, two for each side.
V. 01 – 04/03/2013
added NAS function to back up all kind of IP cameras on the internet
works with free Central Management System (CMS) software for
also compatible with: CAMIP9, CAMIP13, CAMIP14 & ONVIF cameras
LED indicator: the NVR is switched on
LED indicator: an alarm event occurs
LED indicator: the NVR is connected to internet
LED indicator: the NVR is connected to the LAN
LED indicator: SATA hard disk is active
LED indicator: up to two hard disks are installed in the NVR and connected well
Insert a compatible USB flash drive for video backup.
Note: For the list of compatible USB flash drives, refer to the full manual on the
CD-ROM.
Insert a mouse (included).
RS 485 port
Connect an external SATA hard disk
Connect to a monitor that supports high-definition video output (HDMI port).
Note: Use an appropriate adapter (not incl.) to connect a monitor with VGA or
composite connectors.
Connect to local IP cameras via an 8P8C (RJ45) network cable.
Connect to internet via an 8P8C (RJ45) network cable
Connect to an amplifier audio line-in.
Connect to the power supply adapter (incl.).
NVR2
4 ©Velleman nv