2-4.Wiring For The Receiver; 2-5.Installing The Receiver - Panasonic CZ-RWSU2N Installationsanleitung

Wiring Diagram
Terminals for RC
wiring
How to Connect the Wires
Connect the wires from the receiver to the terminals for RC wiring on the indoor unit.
(No polarity)
1 Open the air inlet grill on the side panel. Remove the 1 screw and move it toward the front
(in the direction of an arrow) to remove it. (Fig. A)
2 Wrap the tip of a slotted screwdriver with plastic tape and then insert it under the O-marked
surface of the cover, wiggling the cover free. (Fig. B) (Be careful not to scratch the panel.)
3 After passing the lead wire through the panel, install the receiver in the hole in the panel.
(The projecting parts of the receiver is held in the hole in the panel.)
4 Fasten the receiver's lead wire to the cable clip that is holding the wire from the louver motor.
(Fig. C)
5 Attach the side panel.
6 Put the receiver's lead wire together with other wires such as the louver motor wire, and fasten
them with the cable clip. (Fig. D)
 Use the hole in the upper part of the wiring box to lead it in.
 For more information about wiring and test runs, see the sections on "Wiring for the Receiver" and
"Test Operation" .
Fig. A
Panel
Fig. C
Receiver
2-4. Wiring for the Receiver
Indoor unit
1
2
2-5. Installing the Receiver
Side panel
Air inlet grill
Cable clip
Receiver PCB
CN001
2P white
Slotted screwdriver
Fig. B
(Wrapped with plastic tape)
Plastic tape
Insert it under the
O-marked surface
of the cover.
Fig. D
Panel
CZ-RWST3N
Cover
Cable clip
7