Sharpening The Saw Chain; Initial Use; Switching On And Off; Checking The Automatic Oil System - Parkside FAHE 20-Li A1 Originalbetriebsanleitung

Sharpening the saw chain

NOTE
► You will find detailed information on
sharpening in the sharpening set, e.g. from
Oregon.
► Alternatively, you can use an electrical saw
chain sharpening device and follow the
instructions of the manufacturer.
► If you have any doubts about implementing the
work, the saw chain

Initial use

NOTE
► Comply with regulations regarding noise
protection and local rules. Using the
appliance on certain days (e.g. on Sundays
and public holidays), during certain times
(midday period, night time) or in certain
locations (e.g. health resorts, clinics, etc.)
may be restricted or prohibited.
Switching on and off
Switching on:
♦ Press the safety lock-out
and then press the on/off switch
♦ After the starting process, the safety lock-out
can be released.
Switching off:
♦ Release the ON/OFF switch

Checking the automatic oil system

Before starting work, check the window for the oil
level and the automatic oil system.
♦ Switch the appliance on and hold it over a
lightly coloured floor surface. The appliance
must not touch the ground.
♦ If there is an oil trace, the appliance is operat-
ing correctly.
♦ If there is no oil trace, clean the oil dispenser
or have the appliance repaired by our Customer
Service.
♦ To clean, wipe the residues from the oil dispenser
using a brush or cloth.
PAHE 20-Li A1
should be replaced.
and keep it pressed
.
.

Adjusting the telescopic handle

The telescopic handle
ously by means of the quick release
♦ Activate the quick release
length by pushing or pulling as required.
♦ Close the quick release
the desired working length of the telescopic
handle .
♦ If the screw of the quick release
sened, tighten it again with a hex key.

Adjusting the cutting angle

NOTE
► The cutting angle can be adjusted in 3 stages.
♦ Remove the battery pack
♦ Press the release button
♦ Adjust the angle of the motor unit to the required
position.
♦ Let go of the release button
unit will click into place.
♦ Insert the battery pack

Sawing techniques

WARNING!
► Pay attention to falling clippings.
► Be aware of the danger of branches flying
back.
NOTE
► Place the stop
you work more safely and quietly.
► Now you can begin with the sawing.
Sawing off small branches
♦ Saw small branches (Ø 0–8 cm) from the top
down (see figure).
GB │ IE │ NI │ CY
can be adjusted continu-
.
and adjust the
again, thereby fixing
has loo-
from the appliance.
.
and the motor
back into the appliance.
on the branch. This will help
│
11 ■