Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Output elements
Do not strike the shaft or bearing of the motors.
DO NOT EXCEED THE PERMISSIBLE AXIAL AND RADIAL FORCES ON THE
SHAFT END STATED IN THE CONFIGURATION SPECIFICATION.
Suitable devices should always be used to push on or pull off the output elements
(e.g. the coupler, gear wheel, belt pulley, Fig. 3).
-
Use the tapped hole in the shaft end.
-
Heat up the output elements if necessary.
-
Use a shim to protect the centering in the shaft end pulling output elements off.
-
If necessary, fully balance the motor with the output elements according to ISO1940.
Fig. 3 Pulling off and putting on output elements.
A Shim (protects the centering in the shaft end)
12
ENGLISH
NOTICE
A
610.40068.01
Siemens AG
Werbung
Inhaltsverzeichnis
