Maintenance; Ec Declaration Of Conformity - Makita 4105KB Betriebsanleitung

Operation (Fig. 10)
Hold the tool firmly. Set the base plate on the workpiece
to be cut without the wheel making any contact. Then
turn the tool on and wait until the wheel attains full speed.
Now simply move the tool forward over the workpiece
surface, keeping it flat and advancing smoothly until the
cutting is completed. Keep your cutting line straight and
your speed of advance uniform.
CAUTION:
Be sure to move the tool forward in a straight line and
gently. Forcing and exerting excessive pressure or allow-
ing the wheel to bend, pinch or twist in the cut can cause
overheating of the motor and dangerous kickback of the
tool.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Replacement of carbon brushes
(Fig. 11 & 12)
Replace carbon brushes when they are worn down to the
limit mark. Both identical carbon brushes should be
replaced at the same time.
After use
After use, remove dust from the inside of the tool by run-
ning the tool at an idle for a while. Accumulation of dust in
the motor may cause a malfunction of the tool.
To maintain product safety and reliability, repairs, mainte-
nance or adjustment should be carried out by Makita
Authorized Service Center.
For European countries only
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 98 dB (A)
sound power level: 111 dB (A)
– Wear ear protection. –
The typical weighted root mean square acceleration
2
value is 4 m/s .
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product
is in compliance with the following standards of standard-
ized documents,
HD400, EN50144, EN55014, EN61000
in accordance with Council Directives, 73/23/EEC,
89/336/EEC and 98/37/EC.
Yasuhiko Kanzaki
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes,
Bucks MK15 8JD, ENGLAND
CE 2003
Director
ENG006-1
ENH001-1
7