Safety Regulations; Proper Use - EINHELL RT-SS 120 L Originalbetriebsanleitung

Anleitung_RT_SS_120_L_SPK1:_
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.

1. Safety regulations

The corresponding safety information can be found
in the enclosed booklet.
Caution:
Laser radiation.
Do not look into the beam!
Laser class 2
VORSICHT ! - LASERSTRAHLUNG !
Nicht in den Strahl blicken!
Laserspezifikation
Laser Klasse 2
Ï: 650 nm; P
nach EN 60825-1
Protect yourself and your environment from
accidents by taking the appropriate precautionary
measures.
Do not look directly into the laser beam with the
naked eye.
Never look directly into the laser path.
Never direct the laser beam at reflecting surfaces,
persons or animals. Even a low output laser beam
can inflict injury on the eye.
Caution: It is vital to follow the work procedures
described in these instructions. Using the tool in
any other way may result in hazardous exposure
to laser radiation.
Never open laser module.
16.06.2011 9:27 Uhr
2. Layout (Fig. 1-2)
1 Vacuum extractor unit adapter
2 ON/OFF switch
3 Speed regulator
4 ON/OFF switch for LED light
5 ON/OFF switch for laser
6 Blow-off device
7 LED light
8 Locking screw
9 Scale
10 Pointer
11 Saw blade guard
12 Holding screw
14 Storage compartment for saw blade
14 Sawing table
15 Sawing table insert
14 Clamping lever for saw blade
17 Saw blade holder, top
18 Inspection flap
19 Saw blade holder, bottom
20 Saw blade
21 Laser
22 Adjusting screw for laser
23 Assembly holes
24 Rubber feet
Items supplied
: <1 mW
0

3. Proper use

The fretsaw is intended for cutting square-edged
timber or wood-like workpieces. Round materials may
only be cut with suitable holding devices.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the manufacturer
will be liable for any damage or injuries of any kind
caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
The equipment is to be operated only with suitable
saw blades. It is prohibited to use any type of cutting-
off wheel. To use the equipment properly you must
Seite 9
Fretsaw
Saw blade guard
Assembly tool
GB
9