Operation; Retrospective Output Of Reports; Firmware Update; Firmware Update Via The Miele App - Miele XKM 3100 WCDS Gebrauchsanweisung

en - Operation

Firmware update

via the Miele app
28

Retrospective output of reports

If there are WiFi problems during data transmission, the cycle report
can be transmitted retrospectively.
Open the menu as follows:

Further settings Interface
/
Further instructions and additional information can be found in "Pro-
cess documentation" in the Operating instructions for your washer-
disinfector.
Firmware Update
An update of the module Firmware may be necessary at irregular in-
tervals. Two different procedures are available:
1. Update via the Miele app DataDiary.
2. Update directly via the module XKM 3100 WCDS in your washer-
disinfector. The module must be connected to the internet via a
WPS-enabled router for this.
 Under no circumstances must the internet be accessed via the
washer-disinfector, e.g. via port forwarding!
Make sure that your internet connection or your router is configured
as appropriate.
The current module Firmware version can be selected via the app.
The Miele app DataDiary has an Update wizard which you can use to
update the module Firmware.
For the update you will need:
– Administrator rights for the Miele app.
– The WiFi access code to establish a connection with the internet.
Switch the washer-disinfector on. After approx. 30 seconds the

module is ready for operation.
Log into the app as administrator and follow the wizard instructions.

RS232 Print reports
/ /