Installation; Mounting Of The Sensors - Pepperl+Fuchs LAL-SRW3 Handbuch

WARNING DEVICE LAL-SRW3

Installation

3
3.1
EN
10 - EN
Installation

Mounting of the Sensors

Read the Safety chapter, paying particular attention to the section covering
Installation and Commissioning (see chapter 1.7) before mounting the sensor. Do
not remove the identification plate.
Warning!
Risk of short circuit
Injuries and damage to the device are possible when working with live parts.
Before working on the device, always disconnect the supply voltage.
■
Connect the device to the supply voltage only after completion of the work.
■
During installation, refer to the instructions provided by the oil/petrol separator
manufacturer. Ensure that the suspension mechanism keeps the sensor
permanently at the correct height. Where possible, secure the device in a position
where it can be reached from the manhole opening so that it can be removed
when emptying (disposal) or carrying out maintenance work on the oil/petrol
separator.
Note!
Further information on the installation of the sensor is available in the manuals of
the sensors.