Information And Service - Philips HF390 Gebrauchsanweisung

ENGLISH
10
Problem
----
The values displayed are too low.
After weighing, the display shows
0.0 kg.
Lo
Err
ErrE
Clr

Information and service

If you need information or if you have a problem, please visit the Philips
Web site at www.philips.com or contact the Philips Customer Care
Centre in your country (you will find its phone number in the
worldwide guarantee leaflet). If there is no Customer Care Centre in
your country, turn to your local Philips dealer or contact the Service
Department of Philips Domestic Appliances and Personal Care BV.
Cause
This message is displayed when the
scales are not being used correctly.
The scales had no time to calibrate
correctly and therefore display an
incorrect value.
These scales are not suitable for
weighing less than 5 kilograms.
This message appears when the
batteries are low.
The scales are out off range.
The scales have a measuring range
of 5 kg to 150 kg.
A software malfunction has occurred.
You have pressed the [¢], [£] and set
buttons at the same time.
Solution
If you want to perform a measurement,
wait until the 0.0 kg indication on the
display stops blinking before stepping
onto the scales.
If you want to perform a measurement,
wait until the 0.0 kg indication on the
display stops blinking before stepping
onto the scales.
If you want to weigh a baby, we advise
you to weigh yourself first and then
weigh yourself again while holding the
baby.
Replace the batteries with 2 new lithium
CR2032 batteries.
The scales switch off after 6 seconds. If
this message keeps appearing, take the
appliance to your dealer or the nearest
Philips service centre.
You will have to store your personal data
again.