Connection - Pepperl+Fuchs KVF-103-PF Sicherheitshinweise Und Betriebsanleitung

LAYER THICKNESS SENSOR
Installation
1 Layer thickness
2 Alarm level
3 Sensor KVF-103-PF
4 Water
5 Oil
3.2

Connection

Read the chapter on Safety and, in particular, the section on Installation and commissioning
(see chapter 1.6.1) before connecting the sensor. Do not remove the identification plate.
Warning!
Risk of short circuit
Injuries and damage to the device are possible when working with live parts.
• Before working on the device, always disconnect the supply voltage.
• Connect the device to the supply voltage only after completion of the work.
When making the connection, ensure the polarity of the sensor cables is correct. The loop
resistance of the extension cable should not exceed 20 Ω for the sensor.
Note!
For additional information on connecting the sensors to the warning device, refer to the manual
of the warning device NVO5-11.
5
4
3
1
2
EN
EN - 11