Cleaning And Care - Klarstein 10028190 Anschluss- Und Anwendungshinweise

Heating mode (only for cool and heat producing type)
• Select heating mode by pressing mode button or via remote controller, and heating indicator light
is on.
• Press the up-and-down button to adjust settle temperature (16°C to 30°C).
• Press the wind speed button to select high, medium and low wind speed.
Time mode
• In standby mode, press time button to set time start. Press the up-and-down button to the time
of start (0~24 hours), and time indicator light is on.
• In startup mode, press time button to set time switch-off.
• Press the up-and-down button to the time of switch-off (1~24 hours), and time indicator light is
on.
The product has an automatic water evaporation system. The circulation of condensed water cools
the condenser. This not only increase refrigeration efficiency but save energy.
Discharging the Water Container
If the machine's water container is full, the display screen will present "FL" accompanied by audible
alarm, and the compressor will stop working automatically. At this point, we need to discharge the
water. Discharging steps are follows:
1. Unplug the power cord and remove the exhaust pipe assembly.
2. Remove the conditioner to a appripriate place.
3. Disconnect the plug in drainage outfall to exhaust the water inside the machine.
4. Re-plug the water plug well.
5. Reinstall the exhaust pipe assembly and start the machine.
Cleaning the Surface
• To avoid electrical shock, turn off the conditioner and pull it plug out before conducting mainte-
nance and repair.
• Wipe with a soft cloth. Do not use chemicals, such as benzene, alcohol, gasoline, etc. otherwise,
its surface or even the machine will be damaged.
• Do not let water splash into the conditioner inside.

Cleaning and Care

16