Use And Controls; Cleaning And Care - Klarstein 10027946 Bedienungsanleitung

3. Place the appliance onto a stable, flat and dry surface.
4. Plug the cord set into a 220-240V~A.C. 50Hz earthed electrical outlet. Turn the power on at the
electrical outlet. The blue Power indicator (next to the Power button) will light up and a beep will
sound.
Note: The remote control uses battery. To replace, push clip at bottom of remote inwards & pull out
battery holder, replace battery and push holder back in.
Controls
There are 4 control buttons on the control panel (top of tower fan body) and the remote control.
Operating the Fan
1. With the power cord plugged in, turn the tower fan on by pressing the power button once.
2. Choose a fan speed by pressing the speed button.
3. If required, turn on the oscillation with the OSC button.
4. If required, set up the timer by pressing the timer button (a sequence of 0-7 hours).
5. Turn the tower fan off by pressing the power button a second time.
Important: Always unplug the cord before moving or servicing, do not immerse appliance in water!
• The fan should be cleaned periodically (at least once a month depending on the build-up of dust).
• Clean the body of the tower fan with a soft damp cloth. Always make sure that the appliance is
completely dry before connecting back to the mains supply.
• Do not use gasoline, benzene, thinner, harsh cleaners, etc. as they will damage the tower fan.
NEVER use ALCOHOL OR SOLVENTS.

Use and Controls

A timer can be set for 0-7 hours (in 1 hour increments). Press
this button to cycle up from 1 to 7 and then back to 0 (selected
timer option is displayed on the control panel – add the times up
to determine the full time). All other buttons continue to work
while the timer is in operation. To stop the timer function, set the
time to 0. Once the time has elapsed, the fan will turn off.
Speed button: Once the fan is running (low), press the Speed
button once to increase the fan speed to medium. Pressing
again will increase the speed to high, and once more will re-
turn the fan speed to low. The set speed is indicated on the
control panel display.
OSC button: Once the fan is running, pressing the OSC button
will start the tower fan oscillating (OSC indicator on control
panel will light up). Press a second time to stop the oscillation.
Power button: Once the power has been connected, press this
button to start the tower fan on low speed (the low (L) speed
indicator will light up). Press again to turn off the fan.

Cleaning and Care

8