Bt-Lh80W/Wu Gpi Setting - Panasonic AG-CA300G Bedienungsanleitung

BT-LH80W/WU GPI Setting

To connect this unit with the BT-LH80W/WU and display the RET signal and the R TALLY signal on the
BT-LH80W/WU, it is necessary to set the GPI control signal for the BT-LH80W/WU.
Perform the settings for the following items in the menu of the BT-LH80W/WU. GPI control from this unit
is possible only for GPI1 - 4.
For how to set the menu of the BT-LH80W/WU, refer to the operating instructions for the setting of the
menu for the BT-LH80W/WU.
GPI CONTROL :
Set to ENABLE.
GPI1 :
This controls the ON/OFF of the R TALLY
signal from this unit. To light up the R TALLY
of the BT-LH80W/WU, assign the RED
TALLY to GPI1.
GPI2 :
Set to UNDEF.
GPI3 :
To display the RET signal output from this
unit to the BT-LH80W/WU, assign the YP
to the GPI3. The RET signal will be displayed
on the BT-LH80W/WU only while the RET
signal switching switch on this unit is pushed.
GPI4 :
This will switch the video recording with the
camera recorder as an input signal to display
on the BT-LH80W/WU. The signal from the
camera recorder can be selected and
displayed on the BT-LH80W/WU when the
RET signal switching switch of this unit is not
pushed.
INPUT SEL.SDI :
When the SDI output connector of
the camera recorder and the
BT-LH80W/WU are connected, the
signal from the SDI output
connector of the camera recorder is
displayed on the BT-LH80W/WU.
INPUT SEL.VF :
When the VF connector of the
camera recorder and the VF
connector of the BT-LH80W/WU are
connected, the signal from the VF
connector of the camera recorder is
displayed on the BT-LH80W/WU.
INPUT SEL.YP P
B
Video from the camera recorder that
is being output from the VF OUT
connector of this unit is displayed on
the BT-LH80W/WU.
B
:
R
GPI5 - 8 :
These cannot be controlled from this unit.
P
R
E-20