Conrad BinTin OcTavo Montageanleitung Seite 5

• Shaped metal sheet supporting electrical drive
• Cover
• set of chimes with support disc
• plugs (2), screws (2), replacement threads
FIGURE A (transformer):
Connect secondary wires (8-12 VAC ~) to orange and blue clip.
FIGURE B (battery):
Connect wires from bell push to blue and green clip.
FIGURE 1:
Provide for low voltage power supply according to figure A or B. Drill 2
holes into the wall at the distance of 2.36" (60mm) as per the shaped
metal sheet.
FIGURE 2:
Pull insulated electric wires through central hole of the metal sheet and
connect them according to figure A or B.
FIGURE 3:
Pull cover carefully over the metallic sheet up to the wall.
FIGURE 4:
Attention ! Keep the disc with chimes in one hand while screwing or
unscrewing, to avoid that the disc with the chimes falls.
Do not remove the rubber yet, screw disc with chimes onto the motor
shaft until you feel the resistance of the gear motor.
FIGURE 5:
Remove plastic protections and rubber. Thank you for the perfect
installation !
MADE IN
GERMANY
Contents
Contents
Procedure
Procedure
Patent-No. US 6,640,742 B1
Patentschrift DE 199 55 343