Connecting / Disconnecting
CAUTION
Do not connect or disconnect the port replicator while the computer is powered on or in the
●
Windows 7
Connecting
■
Power off the computer, and disconnect all cables
A
from the computer.
Connect the AC adaptor that came with the computer
B
to the port replicator and plug the other end into an
AC outlet.
CAUTION
Refer to the "Operating Instructions" accompanying computer for information on proper handling
●
of the AC adaptor and AC cord.
E
Set the front of the computer in the latch of the port
C
replicator.
CAUTION
Do not connect the computer to a port replicator
●
while the AC adaptor or other cables is connected
to the computer.
Do not attempt to make connections if there is any
●
object between the computer and the port replica-
tor. Doing so could damage the computer and the
ort replicator.
Put the computer on the port replicator slowly.
D
Slide the lever firmly forward until it reaches the line
E
position.
CAUTION
While connecting the computer to the port replicator:
●
Do not attempt to move the port replicator.
•
Do not open the display wider than necessary (130° or more), and do not apply excessive pres-
•
sure to the LCD.
It is impossible to remove the battery pack.
•
If the computer malfunctions while the port replicator is attached, disconnect the port replicator and
●
check to see if the computer operates normally. If the computer operates normally, the port replicator
may be malfunctioning. Contact your technical support office.
Disconnecting
■
Power off the computer and close the display.
A
Slide the lever all the way back.
B
The computer's connector disengages the port replicator connector
of the port replicator.
Lift up the computer to remove it from the port replicator.
C
10
sleep (
Windows XP
standby) or hibernation mode.
Line
DOCK