Installation Site; Installation And Operation; Installation - AEG PDU 10-2 Betriebsanleitung

4.2

Installation Site

The power distribution units are designed to be installed in a
protected environment. Suitable rooms are dry, relatively dust-
free and free from chemical vapours.
5

Installation and Operation

5.1

Installation

Mounting brackets are installed on both sides of the power
distribution unit at the factory.
Mounting bracket L
Use as socket strip
If you want to use the power distribution unit as a portable
socket strip, remove the brackets described above, if
necessary by using a pair of pliers.
Use as a power distribution unit in network cubicles
The design of the power distribution unit allows it to be used
universally in 19 inch (482.6 mm) standard network cubicles.
In the cubicle frame itself, the power distribution unit can be
mounted either horizontally or vertically. Provision has also be
made for it to be used in the front or rear area. As a result, the
brackets can be used in a variety of ways, in order to take
account of a wide range of installation requirements. If you
wish to change the position of these brackets, remove them
carefully (CAUTION: do not bend!) and then reinsert them in
the required position in accordance with one of the illustrations
below:
Check to make sure the voltage and frequency
data correspond to the values applicable to your
loads. Make sure that the current consumption of
all connected loads does not exceed the type
rating of the power distribution unit.
Mounting bracket R
29
EN