Automatic Preset Tuning - Yamaha TX-492 Bedienungsanleitung

AUTOMATIC PRESET TUNING

You can also make use of an automatic preset tuning function for FM stations only. By this function, this unit performs automatic
tuning and stores FM stations with strong signals sequentially. Up to 40 stations are stored automatically in the same way as in the
manual preset tuning method on page 10.
TX-492RDS only
* Only RDS stations can be stored by this function.
* Refer to page 13–17 for details on RDS stations.
* Parts in shaded area
( ) are present on
TX-492RDS only.
To store stations
1
TX-492RDS
FM/MW/LW
TX-492
FM/AM
2
MEMORY
MAN'L/AUTO FM
MEMO
Flashes.
The automatic preset tuning begins from the frequency
currently displayed. Received stations are programmed to
A1, A2 ... A8 sequentially.
* If more than 8 stations are received, they are also
programmed to the preset station numbers on other groups
(B, C, D and E) in that order.
Press and hold for
about 3 seconds.
AUTO ST
MHz
2 1
When the automatic preset tuning is finished
The display shows the frequency of the last preset station.
Check the contents and the number of preset stations by
following the procedure of the section "To recall a preset
station" on page 10.
To recall a preset station
Simply follow the procedure of the section "To recall a preset
station" on page 10.
TX-492RDS only
*
A recalled station is shown by the frequency or station name
on the display.
Notes
If no station is received by the automatic preset tuning
search, the search finishes after "NOTHING" flashes for
about 3 seconds on the display.
TX-492RDS only
You can replace a preset station by another FM, MW or LW
station manually by simply following the procedure of the
section "To store stations" on page 10.
The automatic preset tuning search will be performed
through all RDS network frequencies until stations are
stored up to E8. If the number of received stations is not
enough to be stored up to E8, the search is finished
automatically after searching all frequencies.
With this function, only RDS stations with sufficient signal
strength are stored automatically. If the station you want to
program is weak in signal strength, tune in to it with the MANUAL
TUNING method (in monaural) and program it by following the
procedure of the section "To store stations" on page 10.
* There may be a case that this function cannot receive a
station which could be received by the automatic tuning
method. This is because this function receives a large volume
of PI (Program Identification) data along with the station.
TX-492 only
You can replace a preset station by another FM or AM
station manually by simply following the procedure of the
section "To store stations" on page 10.
The automatic preset tuning search will be performed
through all FM frequencies until stations are stored up to E8.
If the number of received stations is not enough to be stored
up to E8, the search is finished automatically after searching
all frequencies.
With this function, only FM stations with sufficient signal strength
are stored automatically. If the station you want to program is
weak in signal strength, tune in to it with the MANUAL TUNING
method (in monaural) and program it by following the procedure
of the section "To store stations" on page 10.
11