Connect External Devices - AEG IMS 4452 Bedienungsanleitung

Description of iPod/iPhone/iPad Controls
(10)
You can pause and continue music playback. Press again to
continue playback.
(4)
Press 1 x = Restart of the song from the beginning.
Press 2 x = Skip to the previous song.
Press 3 x = Skip to the song before the previous song,
etc. Press and hold during playback to search
in reverse through the song.
NOTE:
On the device, press the \ button (4) momentarily.
(4)
Press to skip to the next song and the following songs. Press
and hold during playback to search forward through the
song.
NOTE:
On the device, press the \ button (3) momentarily.
RPT (7)
Activates the Repeat function.
MENU (2)
Press this button to bring up the iPod/iPhone/iPad Menu or
to return to the previous menu.
NOTE:
To do this, the music app must already have been started.
OK (4)
Press this button to activate a function or to display the next
menu.
/ (4)
Press these buttons, to scroll up/down the iPod/iPhone/iPad
Menu.
iPod/iPhone/iPad Charging
Your iPod/iPhone/iPad battery is charged as soon as the
iPod/iPhone/iPad is docked. To do this, the unit must be con-
nected to the mains.
NOTE:
• Not all iPod/iPhone/iPad generations support the
charge mode.
• The duration of the charging process depends on
the iPod/iPhone/iPad which is used and its operating
condition.

Connect External Devices

The AUX-IN connection is used to connect analog playback
devices. You can hear the sound of other playback devices
like an MP3 player, a CD player, etc. from the speakers via this
jack.
1. Connect the external unit with a 3.5 mm stereo plug to
the AUX-IN jack on the rear of the device.
2. Now select AUX out mode with the MODE button (3).
The pilot lamp (5 on the device) flashes blue.
3. You will find further instructions in the manual of your
external sound source.
4. Listen to music playback from external playback devices
via the speakers. Press the VOL+/VOL- buttons (6) to set
the volume level.
NOTE:
Set the volume of the external device to a reasonable level.
VIDEO OUT jack (rear of the device)
If you have videos stored on your iPod, iPhone, or iPad, you
can play them also via this device.
• Connect the video jack of your playback device via cinch
cable (RCA) to the VIDEO OUT jack on the rear of the
device.
• Turn on your playback device and select the correspond-
ing input. Refer to the operation instructions for your
playback device.
During playback of a video, the video picture on the iPod/
iPhone/iPad is stopped and is shown on the playback device.
The sound comes from the device speakers.
V-OUT ON/OFF (5)
To turn the VIDEO OUT jack on the rear of the device on
and off.
On = The Video signal is output to the jack.
Off = The Video signal is only shown on the connected
iPod/iPhone/iPad.
Cleaning
• Before cleaning disconnect from mains power supply.
• Clean the device with a soft damp cloth without deter-
gents.
• Do not submerge the device in water.
English
33