Conrad 34060 Gebrauchsanweisung Seite 14

Vorschau ausblenden

Seite von 15

/ 15
Lesezeichen

Verfügbare Sprachen

Maintenance

Clean the filter fabric and the water tank.

Clean the filter system once a week to guarantee a proper humidifying and cleaning process.

(Fig. 5)

1. Pull the mains power cable from the wall socket.

2. Unscrew the back cover, press the elastic buttons at the top of the cover and remove from unit.

3. Remove the filter fabric and the photo-catalytic filter from the cover.

4. Wash the filter fabric with water and place the photo-catalytic filter in the sun for reactivation.

Never wash the photo-catalytic filter with water.

5. Reaffix the dry filter fabric and the photo-catalytic filter to the back cover.

6. Clean the water net with a brush. It is not necessary to remove it from the unit.

7. Replace the back cover on the unit.

8. Pour water into the tank and plug the cable into the wall socket. Push the ON/OFF SWITCH and

then the AIR COOLING button. Switch off all buttons after 5 minutes and pull the plug from the

wall socket. Open the rubber plug on the WATER OUTFLOW and let the dirty water out.

9. Before reactivating the unit, read the section on 'BEFORE OPERATION'.

Instruction

Dry the filter fabric and the photo-catalytic filter when the unit will not be used for a longer period of

time. Also empty all water from the unit.

General malfunctions and troubleshooting

Malfunction

Cause

• No power

No airflow

• Unit not in operation

• Parts of unit damaged

• The ON/OFF SWITCH

The unit does

has not been pushed

not switch off

• Parts of unit damaged

• There are foreign

objects in the back part of

the unit

The unit emits

• The motor is

noises

malfunctioning

• The fan is loose

• Lack of water

• The pump is

malfunctioning

No humidifying

• The water pipe has

dropped off

No back-and-

• The blade motor is

forth

malfunctioning

movement

Attention: Important battery notice

•

We recommend to use alkaline batteries for best possible performance.

•

Never mix old and new batteries or one-way batteries and accumulators.

•

Never use different types of batteries (eg alkaline and zinc carbon) at the same time.

•

Remove the batteries if the device is not used for a long time. Leakage of batteries can cause

permanent damage to the device.

•

Instructions for battery disposal:

Batteries are subject to legal provisions. After use they must therefore be returned to the point of

sale or to a collecting point of public facilities for harmful substances. Batteries may never be

disposed as household waste, in the yellow sack or other. Dispose of batteries only when

completely discharged into a waste batteries collecting container and take precautions against

short circuit (eg by masking the poles).

Safety instructions

Important: Damage caused by not adhering to the operating instructions is not covered by

guarantee. ISOTRONIC accepts no liability whatsoever for any resulting consequent damages.

Only operate the device at its intended voltage.

In case of repairs, only use original spare parts, to avoid serious damage.

Check feed cables and conducting cables connected to the device for breaks or insulation defects.

If you find a defect, or there is visible damage do not use the device.

Repairs or other works, e.g. changing a fuse, etc. may only be carried out by an appropriately

trained, skilled person.

It must be noted that operator or connecting errors lie outside the influence of ISOTRONIC and we

cannot accept any liability for resulting damages.

Always check whether the device is suitable for the respective place where you intend using it.

Troubleshooting

• Connect the power cable properly to the wall

socket

• Push the ON/OFF SWITCH on the unit.