Unpacking Your Ice Maker; Operation - Klarstein 10020109 Handbuch

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

1. Remove the exterior and interior packaging. Check that ice basket and ice scoop is included. If

any parts are missing, please contact our customer service.

2. Clean the interior with lukewarm water and a soft cloth. Take out the ice basket and clean it

3. Find a location for your ice maker that is protected from direct sunlight and other sources of heat

(i.e.: stove, furnace, radiator). Place the ice maker on a level surface. Maker sure that there is at

least 4 inches of space between the back and sides of your ice maker and the wall.

4. Allow one hour for the refrigerant fl uid to settle before plugging ice maker in.

5. The appliance must be positioned so that the plug is accessible.

WARNING: fi ll with potable water only.

1. Take out the ice basket.

2. Clean the interior with diluted detergent, warm water and a soft cloth.

3. Then use the water to rinse the inside parts, and drain out the water by unplugging the drain cap

on the side.

4. The outside of the ice maker should be cleaned regularly with a mild detergent solution and warm

water.

5. Dry the interior and exterior with a soft cloth.

6. When the machine is not in use for a long time, open water drained cap to drain water completely

from water reservoir.

Note: Blowing gas inside the unit is fl ammable, disposal of these material shall be in accordance with

national regulations.

1. Open the cover, remove the ice basket and pour water into water reservoir.

Keep water level below the level mark.

2. Press "ON/OFF" button on the control panel to turn on the unit to begin the ice making cycle.

3. Select the size of the ice cube by pressing the "Select" button. Three sizes: SMALL, MEDIUM or

LARGE can be selected:

If the room temperature is lower than 60℉, it is recommended to select the small or medium ice sign

button in order to avoid ice sticking together.

4. The ice making cycle lasts 6 to 15 minutes, depending on the size of the ice cube selection and

the ambient temperature. In the extreme hot room temperature, ice-making time maybe vary a lot.

5. While the icemaker is on, verify water level periodically. If water pump can't inject water, the ice

maker will stop automatically, and the "

Fill water up to the level mark and press "ON/OFF" button two times again to turn on the unit

again. Allow the refrigerant liquid inside the compressor at least 3 minutes to settle before restarting.

6. The ice maker automatically stops working when the ice basket is full and the "

display in the LCD display widow.

7. Change water in the water reservoir every 24 hours to ensure a reasonable hygiene level.

If unit isn't in use, drain all water left in the tank.