Klarstein 10028293 Gebrauchsanweisung Seite 6

4. Insert the male connector
into the female connector
(from the remote control
receiver to the fan, and
from the remote control to
the terminal block.
7. Lift up the canopy into
place over the mounting
plate. Ensure that you do
not trap any wires.
10. Fit the light kit to the switch
housing by using the three
light kit-fixing screws and
star washers. Ensure that
you do not trap any wires.
5. Connect the wires from
the earthed mains supply
to the terminal block.
8. Fasten the blade assem-
bly to the motor with the
screws and spring wash-
ers already attached to
the motor.
11. Install the light bulb. (R7s
Max 80W, not supplied)
6. Align canopy side holes
with the bracketss. Lift fan
until the screws reach the
bottom of the slots and
then rotate the canopy
counterclockwise until the
screws drop into the slot
recesses.
9. Connect the light kit by
clipping together the two
plastic male/female con-
nectors.
12. Install the lampshade onto
the lamp gallery by rotating
the lampshade clockwise.
6