Getting Started; Energy Saving Tips; Troubleshooting - Klarstein 10027673 Bedienungsanleitung

Setting the Temperature Control
Your unit has only one control for regulating the temperature in the compart-
ment. The temperature control is located at the upper right hand side of the
compartment.
• The first time you turn the unit on, set the temperature control to „5".
• The range of the temperature control is from position wo• to „5". After 24
to 48 hours, adjust the temperature control to the setting that best suites
your needs. The setting of „3" or „4" should be appropriate for home or office
use. • To turn the appliance off, turn the temperature control to „0".
NOTE: Turning the temperature control to „0" position stops the cooling cycle but does not shut off
the power to the unit. If the unit is unplugged, has lost power, or is turned off, you must wait 3 to 5
minutes before restarting the unit. If you attempt to restart before this time delay, the unit will not
start.
• The unit should be located in the coolest area of the room, away from heat producing appliances,
and out of the direct sunlight.
• Let hot foods cool to room temperature before placing in the unit. Overloading the unit forces the
compressor to run longer.
• Be sure to wrap foods properly, and wipe containers dry before placing them in the unit. This cuts
down on frost build-up inside the unit.
• Unit storage bin should not be lined with aluminum foil, wax paper, or paper toweling. Liners in-
terfere with cold air circulation, making the unit less efficient.
• Organize and label food to reduce door openings and extended searches. Remove as many items
as needed at one time, and close the door as soon as possible.
Certain problems can be solved easily without calling out an engineer. Before conacting your local
Service Centre, please carry out the checks listed underneath. If you are unable to identify or solve
the problem, contact your local Service centre. Before telephoning, make a note of the model, serial
number and purchase date of your machine, the Servie Center will require this information.
Problem
Unit does not operate. Not plugged in.
Turns on and off
frequently.

Getting Started

Energy Saving Tips

Troubleshooting

Possible Cause
The circuit breaker tripped or a blown fuse.
The unit temperature control is set at „0" position.
The room temperature is hotter than normal.
A large amount of food has been added to the unit.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The unit does not have the correct clearances.
6