Klarstein HOT SPOT WAVE Bedienungsanleitung Seite 21

Wall Mounting Installation
1 Drill two holes on the wall from the dimension.
2 Fix two anchors into the wall and fix wall-mounting support on the wall by screw.
3 Install the Heater on the wall mounting support and remaining two screws holes
from lower wall mounting support.
4 Remove Heater and drill two holes on the wall from the marking and install two
anchors into the wall by hammer.
5 Install the Heater on the wall mounting support and fix it by screw on the bottom of
the Heater.
EN
21