Klarstein PUREFINA Bedienungsanleitung Seite 21

INSTALLATION OF WATER INLET AND OUTLET
Installation place
Place the machine on a flat and stable surface.
1. Installation of inlet water T valve
Clean the installation area,close the inlet water valve,take apart the faucet or angle
valve, then connect the inlet water T valve. Finally connect to the original faucet or
angle valve.
Attention: Connection of screw thread should be sealed with tape or 0 ring to
avoid leakage.
2. Connection of inlet water port:
Connect one side of PE pipe to the inlet water valve,and another side to the inlet
water port on the machine.
3. Installation of faucet
According to the required place of faucet, drill a Ø12-mm hole on the stainless
steel sink. Then fix the faucet.
1
quick connector
4. Connection of drinking water port
Connect directly with the connecting rod of faucet. Cut the 1 /4" PE pipe to a
suitable length, one side insert to the quick connector and the other side connect
to the port of drinking water on the machine.
5. Connection of drain water port
Take a suitable length of 1/4" PE pipe to connect with the port of drain water on
the machine.And connect another side to the drain line and fix the PE pipe to avoid
drop.
6. Flush the cartridge
lnstall all the cartridges before flushing.
1. Flushing of PP+C cartridge: After all the installation, turn on the purified water
tap to flush PP+C filter about 10-20 minutes until the water is clean, then turn
off the purified water tap.
2. Flushing of T33 cartridge: After all the installation, turn on the drinking water
tap to flush about 10-20 minutes until the water is clean.
Attention
screw nut
pad 1 pad 2
EN
21