EINHELL RT-SB 305 Bedienungsanleitung Seite 20

Anleitung RT-SB 305 U_SPK1:_
GB
9.4. Freehanded cuts (Figure 25)
One of the most outstanding features of a bandsaw
is the ease with which it allows you to make curved
cuts and radii.
Lower the blade guide (11) down to the
workpiece. (See 7.6.)
Switch on the saw.
Hold the workpiece securely on the table (15)
and guide slowly through the blade (25).
Freehanded cuts should be made at low feed
speed so that you can guide the blade (25)
along the required line.
It often pays to first cut off surplus curves and
corners up to about 6 mm from the cutting line.
In the case of curves which are too tight for the
blade to cut correctly, it can help to make a
series of close-lying cuts at right angles to the
curved line. When you saw the radius the
material will simply drop off.
10. Maintenance
Caution! Pull out the power plug first.
Remove dust and dirt regularly from the
bandsaw. Cleaning is best carried out with a fine
brush or a cloth.
Do not use caustic cleaning agents for cleaning
plastic.
11. Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
12. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
20
03.10.2008 9:40 Uhr Seite 20
All manuals and user guides at all-guides.com