Velleman CHLSC8 Gebrauchsanweisung Seite 8

6.1 Physical connection
1. Connect the LED strip with the controller via the external
dedicated connector.
• Red cable: 12V (or 24V)
• Green cable: Data signal
• White cable: 0V or GND
2. Connect an external constant voltage LED power supply to the
external red and white cables from the LED strip.
3. Connect an external switch or switches via the 2 white dotted
cables.
Refer to the illustrations on page 3 & 4 of this manual.
Warning: never connect the power supply to these wires!
This will damage the controller.
4. It is possible to extend the standard 5m digital white LED strip
with more digital white LED strips.
Refer to the illustrations on page 5 of this manual.
Warning: Each 5 meter LED strip need power supply
connections on both sides!
6.2 configuration
The installation and configuration need to be done before installing
the controller behind the switch. The configuration can be done via
the integrated push buttons on the backside of the controller.
Adjust operation mode:
This controller can control different types of digital LED strips. This
setting can be changed via the following steps:
1. Turn off the switch or switches.
Press 2 seconds on "+/speed" push button.
2.
A running light now starts with a certain pattern. With each
press of the "+/speed" button, the pattern will change.
the patterns are:
• 1234 => selection for white color digital LED strips
• 1324
• 2134
• 3124
V. 01 – 15/09/2023
CHLSC8
8 ©Velleman Group nv