EINHELL 23.602.05 Bedienungsanleitung Seite 18

Anleitung NMK 2700_SPK1:Anleitung MKA 7000_D
GB
1) Dust filter
To remove the filter cover, press the latch on the
filter cover down and pull it out and away. Then
remove the activated carbon filter. Use a vacuum
cleaner or tap the dust filter gently to remove the
dust. If the filter is very dirty, wash it carefully with
warm water. Then allow to dry thoroughly.
2) Activated carbon filter
The activated carbon filter is located behind the dust
filter and cannot be washed. Its service life is
dependent on the operating conditions. The filter
should be inspected and replaced if necessary. The
filter cover then has to be fitted back on the device
with both filters.
B) Cleaning the housing
Use only gentle cleaner and a soft cloth to clean
the housing. Never use aggressive media, petrol,
alcohol or thinner. Only fit the filter back in place
when thoroughly dry.
C) At the end of the season
At the end of the season, let the device run for
approx. 3 hours in the fan function (FAN).
Then roll up the power cable and store it in the
storage compartment provided at the back of the
device.
Place a suitable container beneath the
condensate drain and remove the plug. The
trough then empties (see Chapter 7).
Re-insert the plug in the condensate drain.
Important: If the plug is not inserted or is not
inserted correctly, water will escape the next time
the device is used again.
Clean the filter and the housing.
Re-insert the filter when thoroughly dry.
Store the device in an upright position, preferably
packed in the original box, in a dry and dust-tight
location.
10. Ordering spare parts
Please provide the following information on all orders
for spare parts:
Model/type of appliance
Article number of the appliance
ID number of the appliance
Number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
11. Circuit diagram (Fig. 10)
18
30.10.2006 7:27 Uhr
12. Troubleshooting
If the device is operated properly you should
experience no problems with malfunctions or faults. In
the event of any malfunctions or faults, please check
the following before you contact your customer
services.
Seite 18