Hitachi CC 14SE Bedienungsanleitung Seite 9

English
7. Service parts list
A: Item No.
B: Code No.
C: No. Used
D: Remarks
CAUTION
Repair, modification and inspection of Hitachi Power
Tools must be carried out by an Hitachi Authorized
Service Center.
This Parts List will be helpful if presented with the
tool to the Hitachi Authorized Service Center when
requesting repair or other maintenance.
In the operation and maintenance of power tools,
the safety regulations and standards prescribed in
each country must be observed.
MODIFICATIONS
Hitachi Power Tools are constantly being improved
and modified to incorporate the latest technological
advancements.
Accordingly, some parts (i.e. code numbers and/or
design) may be changed without prior notice.
NOTE
Due to HITACHI's continuing program of research and
development, the specifications herein are subject to
change without prior notice.
Information concerning airborne noise and vibration
The measured values were determined according to
EN50144.
The typical A-weighted sound pressure level: 95 dB (A).
The typical A-weighied sound power level: 108 dB (A).
Wear ear protection.
The typical weighted root mean square acceleration value
does not exceed 2.5 m/s
Information about power supply system of nominal
voltage 230 V~
Under unfavorable mains conditions, this power tool
may cause transient voltage drops or interfering voltage
fluctuations .
This power tool is intended for the connection to a
power supply system with a maximum permissible sys-
tem impedance Z of 0.07 Ohm at the interface point
MAX
(power service box) of the user's supply.
The user has to ensure that this power tool is connected
only to a power supply system which fulfills the require-
ment above.
If necessary, the user can ask the public power supply
company for the system impedance at the interface point.
Information about the circuit-breaker swtich of
nominal voltage 230 V~
This tool should be used only if it is connected to a 16 A
Fuse with gl disconnection characteristic.
8
2 .