Checking The Charge Status Of The Rechargeable Battery; Used Batteries; Storage - Parkside PAP 20 B3 Originalbetriebsanleitung

2. To insert the battery (4),
place it on the guide track
and push it into the appli-
ance. It will audibly snap in.
Checking the charge
status of the re-
chargeable battery
The battery charge status indi-
cator (3) signalises the state of
charge of the battery (4).
Press the button (2) on the bat-
tery. The state of charge of the
battery is displayed by illumi-
nating the 3-colour LED lights of
the state of charge display.
3 LEDs light up
(red, orange and green):
Battery is fully charged.
2 LEDs light up
(red and orange):
Battery has a residual charge.
1 LED lights up (red):
Battery has to be charged
Only charge the battery
(4) when the red LED on
the charge status indica-
tor (3) is on.

Used batteries

• If a fully recharged bat-
tery lasts for considerably
shorter operating times,
the battery is used up and
needs to be replaced. Only
use an OEM battery pack
replacement available from
our Customer Service.
• Always take heed of
the applicable safety in-
structions as well as the
environmental protection
regulations and information
(see "Cleaning and Mainte-
nance").

Storage

• Remove the battery before
storing the unit for longer
periods of time (e.g. hiber-
nation).
• Store the battery only in
a partially charged state.
During prolonged storage,
2 to 3 LEDs should be illu-
minated.
• During a longer storage
period, check the state
GB MT
49