Getting Started; Bluetooth ® Pairing - THOMSON WHP-6017 Bedienungsanleitung

4. Getting Started

• The headset is equipped with a rechargeable battery.
The battery must be fully charged before using the
device for the first time.
• Ensure that the headset is switched off before charging it.
• Begin charging the power pack by connecting the
included USB charging cable to the charging terminal
(4) as well as to the USB connection of a PC/laptop.
• Alternatively, you can charge the headset using a
suitable USB charger. Please refer to the operating
instructions for the USB charger used.
• The indicator light remains steadily lit in white during
the charging process.
• It takes around 4 hours until the battery is completely
charged.
• Once the charging process is complete, the indicator
LED goes out.
• Disconnect all cable and mains connections after use.
5. Operation
5.1 Bluetooth pairing
®
Note – Pairing
• Make sure that your Bluetooth
device is on and Bluetooth
• Make sure that your Bluetooth
device is visible for other Bluetooth
• For more information, please refer to the operating
instructions of your terminal device.
• The headset and the terminal device should be no further
than 1 metre apart. The shorter the distance, the better.
• Make sure that the headset is fully charged and
switched off.
• Press and hold the multifunction button (1) for about 6
seconds to turn the headset on. It automatically enters
pairing mode. The white and blue indicator lights flash
alternately. The headset is searching for a Bluetooth
connection.
• Open the Bluetooth
®
device and wait until "6005BT" appears in the list of
Bluetooth devices found.
®
• Select "6005BT" and wait until the headset is listed as
connected in the Bluetooth
device.
-capable terminal
®
is activated.
®
-capable terminal
®
devices.
®
settings on your terminal
settings on your terminal
®
Note – Bluetooth
Some terminal devices require a password in order to
connect to another Bluetooth
• If your terminal device requests a password for
connection to the headset, enter 0000.
Note
• If pairing was successful, the display flashes quickly
in blue ten times and then flashes once every 6
seconds.
• If pairing was not successful, the display remains
permanently illuminated, and you will have to
perform pairing again.
• The display will go out if pairing takes longer than
60 seconds.
• If this happens, you will need to switch the headset
off and on again if you want to pair it with your
terminal device again.
• You can now use the headset.
5.2. Automatic Bluetooth
successful pairing)
• Make sure that the headset is switched on.
• Press the multifunction button (1) to automatically
connect the headset with your terminal device.
• You can now use the headset.
Note – Connection impaired
If the Bluetooth
automatically, check the following:
• Check the Bluetooth
device to see whether "6005BT" is connected. If
not, repeat the steps listed under 5.1. Bluetooth
®
pairing.
• Check whether obstacles are impairing the range. If
so, move the devices closer together.
• The performance can also be affected by a weak
battery.
password
®
device.
®
connection (after
®
connection is not established
®
settings of your terminal
®
®
3