Replacing The Lamp; Troubleshooting - Zanussi ZFV316K Benutzerinformation

1
2
2. Slightly tilt the front of the filter
downwards (2), then pull.
Repeat the first two steps for all filters.
3. Clean the filters using a sponge with non
abrasive detergents or in a dishwasher.
The dishwasher must be set to a low
temperature and a short cycle. The
grease filter may discolour, it has no
influence on the performance of the
appliance.
4. To mount the filters back follow the first
two steps in reverse order.
Repeat the steps for all filters if applicable.
6.3 Replacing the charcoal filter
WARNING!
The charcoal filter is NON-washable! The
filter cannot be regenerated!

7. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
You cannot activate the appliance.
To replace the charcoal filter:
1. Remove the grease filters from the
Refer to "Cleaning the grease filter" in this
chapter.
2. Turn the filter counterclockwise (1) and
To mount the filters back follow the steps in
reverse order.

6.4 Replacing the lamp

This appliance is supplied with a LED lamp
and separate control gear (LED driver).
These parts can be replaced by a technician
only. In case of any malfunction refer to
"Service" in the "Safety Instructions" chapter.
Possible cause
The appliance is not connected to a
power supply or it is connected in‐
correctly.
52
appliance.
then pull (2).
Remedy
Check if the appliance is correctly
connected to the electrical supply.
1
2