Product Description; Installation; Preparation; Preparing The Connection To The Flue - Dovre SAGA 101 Einbauanleitung Und Gebrauchsanweisung

Remove combustible material such as lino-
leum, carpets/rugs and similar materials
below the fireproof protective plate.
Keep sufficient distance between the appli-
ance and combustible materials such as
wooden walls and furniture.
The connecting tube also radiates heat.
Ensure that there is sufficient distance or a
shield between the connecting tube and com-
bustible material.
The rule of thumb for a single-walled tube is a
distance of 3x the diameter. If a lining shell is
fitted around the tube, a distance of 1x the dia-
meter is permissible.
Carpets and rugs must be at least 80 cm away
from the fire.
Use a fireproof floor plate to protect a flam-
mable floor from any ash that may fall in front
of the stove. The floor plate must comply with
national standards.
For the dimensions of the fireproof protective
plate: see the appendix "Distance from com-
bustible material".
For further requirements with respect to fire
safety, see the appendix "Distance from com-
bustible material".

Product description

1
2
3
4
D OVRE
8
5
6
09-20022-082
1. Door
2. Latch
3. Air control scraper
4. Leg
5. Flue gas connection
6. Connection to outside air
Features of the appliance
The appliance comes with a handle holder (see
'Holder Cold Hand') for the removable handle.
The customer can attach this holder under the
right-hand front leg, using the hexagonal nut sup-
plied. This means the leg does not need to be
unscrewed for attaching the holder.
The appliance can be connected to the chimney
at the rear or at the top.
The base plate is grooved. The ashes that accu-
mulate in the grooves act as an insulating layer to
protect the base plate.

Installation

Preparation

Please check the appliance for damage caused
during transport or any damage or defects imme-
diately after delivery.
If you detect transport damage or any other
damage or defects, do not use the appliance
and notify the supplier.
Preparing the connection to
the flue
When connecting the appliance to the chimney you
have the choice of connecting via either the side, the
rear or the upper side.

Installing and connecting

1. Position the appliance in the correct place, and
make sure it is level.
2. Connect the appliance to the flue hermetically.
Subject to change because of technical improvements