Initial Operation And Notes; Initial Operation; Notes For Customer Before Use; Time, Time Zone And Calendar Setting - FanJu FJ3365-DCF Handbuch

2 INITIAL OPERATION AND NOTES

2.1 Initial Operation

 Open the weather station battery compartment, insert 2 x AA batteries observing polarity [ "+" and " –" marks]
 Remove the battery compartment on the Wireless Remote Sensor, insert 2 x AA batteries observing the correct
polarity (+ and - marks) and close the battery compartment.
 When the power is connected all the icons on the LCD display will light up for 3 seconds, you will hear a beep tone
and the weather station will start to detect the indoor temperature and humidity
 The weather station will start to make a connection to the outdoor remote sensor. This operation takes about 3
minutes and is displayed by a flashing reception RF icon "
 Once the weather station has created a connection to the outdoor sensor the clock will start automatically searching
for the DCF Signal to set the time and date. The radio mast icon " " will flash showing it is searching for signal, it may
take up to 7 minutes to search.

2.2 Notes for Customer before Use

 During the DCF signal search mode only the "
have no function. And backlight will not keep lighting during this moment even if the adapter plug in. Press the "+"
button it can cancel the DCF signal search and all buttons and backlight will function.
 If weather station failed to receive transmission from outdoor sensor ("- -"display on the main station LCD), press and
hold "-" button for 3 seconds to receive transmission manually. RF icon "
station to re-receive the data from outdoor sensor. Or
connect the sensor and station again.

3 TIME, TIME ZONE AND CALENDAR SETTING

3.1 Manual Time Setting

 Press the "MODE" button, can switch the display calendar, second or alarm time
 Press and hold down the "MODE" button for 3 seconds, the 12/24 hour mode display starts to flash. Now use"+" and
"-" buttons to set the correct 12/24 hour mode.
 Press "MODE" to confirm your setting, the °C or °F format display starts to flash. Now use "+" and "-" buttons to
select
 Press "MODE" to confirm your setting, the air pressure unit (near the moonphase) format display starts to flash. Now
use "+" and "-" buttons to select
 Press "MODE" to confirm your setting, the Time Zones starts to flash. Now use "+" and "-" buttons set a correct time
zone (-12 to +12).
 Press "MODE" to confirm your setting, the Hour display starts to flash. Now use "+" and "-" buttons to set the correct
hour.
 Press "MODE" to confirm your setting, the Minute displays starts to flash. Now use"+" and "-" buttons to set the
correct minute.
 Press "MODE" button to confirm your setting, the Month and Date icon display starts to flash. Now use "+" and "-"
FJ3365-DCF Manual
"
in the "Remote Sensor" display area on the receiver.
SNOOZE/LIGHT
open the sensor battery compartment, press the TX button to
16
" and "+" button will function, all other buttons
" flashes on the LCD and the weather