Siemens TE515-Serie Gebrauchsanleitung Seite 36

en Maintenance and daily cleaning
The rinse procedure stops automatically
after about 1 minute.
■ Empty the container and clean the milk
tube (6c).
In addition to this, clean the milk system
thoroughly at regular intervals (by hand or
in the dishwasher).
W Risk of burns!
The milk frother (6) gets very hot. After use,
always let it cool down before you touch it.
Dismantling the milk system for cleaning:
■ Pull the milk frother (6) forward out of the
appliance.
■ Dismantle the milk frother into its
individual parts (6a to 6d) (see figure C
at the start of the operating instructions).
■ Clean the individual parts with a detergent
solution and a soft brush. If necessary,
soak in a warm detergent solution.
32
■ Rinse all parts with clear water and dry
them.
N.B.: All the parts of the milk frother and the
milk tube can also be put in the dishwasher.
■ Reassemble all the parts and replace fully
in the appliance.
W Risk of scalding!
Use this appliance only after the milk frother
(6) has been fully assembled and installed.
Cleaning the brewing unit
Clean the brewing unit regularly!
To pre-clean the brewing unit automatically:
■ Select k by turning the rotary knob (15).
■ Place an empty glass under outlet (6a).
■ Press the start button (10).
The appliance rinses.
In addition to the automatic cleaning
programme, the brewing unit (5a) should
be removed regularly for cleaning. (See
figure E at the start of the operating
instructions.)
■ Switch the appliance off at the power on/
off switch O / I (9). No buttons are lit.
■ Open the door (5b) to the brewing unit.
■ Slide the red lock (5e) on the brewing unit
(5a) completely to the left.
■ Press the eject lever (5d) down fully. The
brewing unit is released.
■ Grasp the brewing unit (5a) by the
recessed grips and remove carefully.