For Your Safety - AL-KO HW 604 INOX Bedienungsanleitung

Introduction
Please read the operating instructions carefully
before you use the domestic water system to
prevent accidents and ensure the trouble-free
operation of the system. Make sure you keep the
instructions at hand for quick reference. If you
resell your pump or give it to another user, please
include these instructions in the sale or the gift.
The following symbols
instructions:
DANGER
!
This symbol draws your attention to
work processes
procedures that have to be carefully
observed in order to prevent serious
injury to the user or another person.
CAUTION
This symbol draws your attention to
information you need to ensure that
your system is not damaged due to
improper or careless use.
PLEASE NOTE
The information symbol draws your
attention
requirements.

For your safety

The domestic water system may only be
!
connected to an electrical device which
is compliant with DIN/VDE 0100, Parts
737, 738 and 702 (swimming pools).
Make sure that fuse protection in the
form of a 10 A automatic cut-out and a
fault current guard circuit with a nominal
fault current of 10/30 mA is installed.
The supply voltage and current specified
!
on the type plate must be identical with
the voltage and current of your electrical
system.
If you need to connect your domestic
!
water system to an extension cord,
make sure that the cable is 3 x 1.5 mm
that it corresponds to type H07RN-F and
is compliant with DIN 57282/57245. The
connector must be splash-proof. Cable
drums must be completely unwound.
are used
or operating
to essential technical
!
−
−
!
in the
Do not operate the system if it is dam-
!
aged. Necessary repairs must be carried
out in a qualified AL-KO service centre.
Never use the electric cable to lift, carry
!
or attach the system to another object.
Do
unplugging the system.
Make sure that the system is unplugged
!
before
repair or cleaning work. In the event of a
malfunction, immediately unplug the
system. Make sure that the plug does
not get wet.
Do not attempt to make any changes or
!
modifications to the device by yourself.
You may endanger your life or invalidate
the warranty.
Risk of injury due to hot water!
!
The water in the pump can heat up signif-
icantly, during longer periods of operation
(>10 min) against closed outlet side.
This hazard can occur due to:
− side under compression closed
− lack of water in the suction pipe
− improper installation
− faulty pressure switch
In this case:
− isolate the pump from the mains
,
2
− allow the pump and water to cool down
− check water level on inlet side
− check pipes for water-tightness
− check installation
− check pressure switch
− only restart pump after rectifying the
GB 1 
Please make sure that the system is
not operated by anyone
who has not read or does not fully
understand the operating instructions
or
is under the age of 16.
The domestic water system may not
be used for any other than its
designated use. Before putting the
system into operation, make sure
that
– the pump,
electric cable and the plug are not
worn or damaged.
not pull on the
beginning any
cause of the fault
reservoir, the
cable when
maintenance,