Environmental Protection - Worx WG743E Serie Originalbetriebsanleitung

MAINTENANCE
WARNING: Stop the mower and remove the
safety key before removing the grass bag.
NOTE: To ensure long and reliable service,
perform the following maintenance procedures
regularly. Check for obvious defects such as a
loose, dislodged or a damaged blade, loose fittings,
and worn or damaged components. Check that
the covers and guards are all undamaged and are
correctly attached to mower. Carry out any necessary
maintenance or repairs before operating mower.
If the mower should happen to fail despite regular
maintenance, please call our customer helpline for
advice.
BLADE SHARPENING
KEEP BLADE SHARP FOR BEST MOWER
PERFORMANCE.
WEAR PROPER EYE PROTECTION WHILE REMOVING,
SHARPENING, AND INSTALLING BLADE. ENSURE THAT
SAFETY KEY IS REMOVED.
Sharpening the blade twice during a mowing season
is usually sufficient under normal circumstances.
Sand causes the blade to dull quickly. If your lawn
has sandy soil, more frequent sharpening may be
required.
REPLACE BENT OR DAMAGED BLADE IMMEDIATELY.
WHEN SHARPENING THE BLADE:
1. Make sure blade remains balanced.
2. Sharpen blade at the original cutting angle.
3. Sharpen cutting edges on both ends of blade,
removing equal amounts of material from both ends.
NOTE:
1. Be sure the mower is turned off and remove the
key.
2. Place the mower in stand up storage mode.
TO SHARPEN BLADE IN A VISE (SEE Fig.L1)
1. Be sure the bail handle is released, the blade has
stopped and the safety key removed before removing
the blade.
2. Remove blade from mower. See instructions for
removing and attaching blade.
3. Secure blade L1-1 in a vise L1-2.
4. Wear safety glasses and be careful not to cut
yourself.
5. Carefully file the cutting edges of the blade with a
fine tooth file L1-3 or sharpening stone.
6. Check balance of blade. See instructions for blade
balancing.
7. Replace blade on mower and tighten securely. Refer
to instructions below.
BLADE BALANCING (SEE Fig.L2)
Check balance of blade by placing center hole in blade
L2-1 over a nail or screwdriver shank L2-2, clamped
Cordless Lawn mower
horizontally in a vise L2-3. If either end of the blade
rotates downward, file that end. Blade is properly
balanced when neither end drops.
BLADE MAINTENANCE (SEE FIG. M1, M2)
Renew your metal blade after 50 hours mowing or 2
years, which ever is the sooner-regardless of condition.
Follow these procedures to remove and replace the
blade. You will need garden gloves (not provided) and
a spanner wrench (not provided) to remove the blade.
Hold the blade (19) and unscrew the blade bolt (18)
counter-clockwise using a spanner wrench, and then
remove blade.
To re-assemble, position the blade (19) with the cutting
edges towards the ground. Then securely tighten the
blade bolt (18).
STORAGE (SEE Fig. K1, K2)
Stop the mower and always remove the safety key.
Clean the exterior of the machine thoroughly using
a soft brush and cloth. Do not use water, solvents or
polishes. Remove all grass and debris, especially from
the ventilation slots.
Turn the machine on its side and clean the blade area.
If grass cuttings are compacted in the blade area,
remove with a wooden or plastic implement.
Store the machine in a dry place. Do not place other
objects on top of the machine.
To aid storage, release the Lock Cam Lever, and fold the
upper handle as shown in Fig. K1, K2.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities or
retailer for recycling advice.
17
EN