Specific Information; Checking And Maintenance - CAMP GYRO4 Bedienungsanleitung

O This product is warranted against any faults in materials or manufacture for 3 years from the purchase

SPECIFIC INFORMATION

INSTRUCTIONS FOR USE
Summary
C.A.M.P. Gyro4 is a device designed to connect two, three or four elements between each other, which need
points of EN 795:2012 and EN 354:2010. Gyro4 is also tested according to the American ANSI / ASSP Z359.12-2019
standard. By way of non-exhaustive example, some applications are: multi-anchorage with self-orientable points,
multiple harness connections, anti-twist function for lanyards, cross-hauling operations, tyrolean traverses, rescue
operations. This product is intended for use to protect and prevent against the risk of falling from a height in rescue
operations, in work at a height, in the practice of mountaineering, rock-climbing and other vertical sports that use
similar techniques.
Use
Gyro4 must be connected to other elements of the system through compatible connectors inserted in the
attachment holes [2a] ( ). Use EN 362 class B or ANSI Z359.12 connectors for industrial use or EN 12275
for mountaineering use; in the case of permanent connections, select by preference quick links (Class Q). Avoid
transverse stresses on the connectors ( ), preferring the use of the appropriate anti-rotation inserts [3]
( ). Use only C.A.M.P. anti-rotation inserts. Alternatively, it is possible to directly connect a rope (EN 1891 or EN
892) or webbing (EN 565) knotted inside the attachment holes [2a], in this case removing the anti-rotation insert
[3] ( ). The maximum applicable load (WLL) is 300 kg (~3 kN). The breaking load (MBL) is 26 kN. The maximum
). Prevent Gyro4 from hitting uneven surfaces or sharp edges that
could compromise its strength. ( . If used in a fall arrest system, the system must limit the peak force below 6
of force direction. Do not stay above the anchor point: risk of failure/injuries in case of fall. Take measures to avoid
pendulum. Gyro4 should not be used alone as a fall arrest component. Gyro4 can be used in a fall arrest system
when combined with an EN 355 energy absorber and EN 362 connectors; in this case the maximum length of the
string-Gyro4-absorber-connector system must never exceed 2 m and must be connected to the attachment element
(A) of a EN 361 full body harness. Use adequate rescue equipment and provide adequate training for the work crew

CHECKING AND MAINTENANCE

Check the correct rotation of the swivel balls [2] at each use in case of dirt, clean with a blast of compressed air and/
or immerse in fresh water and subsequently dry in a ventilated environment. After cleaning, the mechanism can be
lubricated. Cleaning and lubrication are recommended after each use in a marine environment.
REVISION
normal inspection required before, during and after each use, this product must be inspected by a skilled person
: keep this literature for inspection and reference for the life of the device.
should be withdrawn from service immediately:
• excessive wear of the swivel balls [2] at the attachment holes [2a]
10