Basic Working Techniques - Husqvarna K 770 Bedienungsanweisung

•
2
•
3
•
• Make the final separating cut from the top of the pipe
pulling backwards, without involving the upper
quadrant of the blade. Adjust the blade guard to full
forward position for maximum protection.
WARNING:
supported, it should not pinch the blade
when separated in section 5. However
be alert if the blade is pinched during the
final separation. If the blade is pinched in
the lower section, the product may pull
forward away from the operator, rather
then resulting in a rotating kickback.
1447 - 004 - 04.05.2021
4
5
If the pipe is properly
To prevent a kickback
WARNING:
there is a risk of kickback. Take care when
using your power cutter and make sure that
the blade is never pinched in the kickback
zone.
WARNING:
the blade in an existing cut.
WARNING:
piece cannot move during a cutting
operation.
WARNING:
working technique can eliminate kickback
and its dangers.
• Always support the work of piece so that the cut can
keep open when cutting through. When the cut is
open there is no kickback. If the cut is closed and
pinches the blade, there is a risk of kickback.

Basic working techniques

WARNING:
one side. This can prevent the free
movement of the cutting blade. The cutting
blade can break and cause injury to the
operator or bystanders.
WARNING:
of the cutting blade. The cutting blade can
break and cause injury to the operator or
bystanders. Only use the cutting edge.
WARNING:
blade is installed correctly and does not
show signs of damage.
WARNING:
existing cut made by a different blade, make
a sure that the slot is not thinner than your
blade as that can result in binding in the
cutting slot and a kickback.
Avoid situations where
Be careful when you put
Make sure that the work
Only you and proper
Do not pull the product to
Do not grind with the side
Make sure that the cutting
Before cutting in an
19