Midea MSVI-40 Bedienungsanleitung Seite 18

OPERATING INSTRUCTIONS
Plug in the power adapter, after a "beep" tone, the fan is on standby.
I. Remote Controller (Fig.8)
" " ON/OFF KEY
Press this button under standby mode,the fan starts at memorial speed which it
worked last time.Press this button when the fan is working,it will be turned off to
standby state.
" " DRIVE PLATE
When you rotate the drive plate clockwise,the speed increases from the following
manner:normal wind 01......When you rotate the drive plate counter-clockwise,the
speed decreases from the following manner:normal wind 12......
" " MODE KEY
Repeat press this button, the wind will be switched in order of "normal wind - natural
wind - sleep wind - comfort - silence - normal wind - ... ".
Normal wind: The wind speed is constant set by the wind level, when the "normal
wind" icon is lit, 01 - 12 levels are normal wind;
Natural wind: Fan will simulate natural wind according to pre-programmed manner,
the wind speed changes in accordance with the program, which makes people
feeling idle, naturally and it likes to be in the nature.
Sleep wind: The wind weakens step by step during the preset time until stop. And
then the fan switches automatically off so that man can drop asleep.
Comfortable wind: The speed will be changed with the room temperature intelligently.
If the temperature is lower than 20°C,the fan will stop working.If the temperature is
higher than 20°C, the fan will work again. When you choice comfortable wind, the
icon will be lighted and the IDM display"00".
Silence: Press this key to make the fan switch to the mute mode, in which the noise
is low and the mute indicator "
to the normal air mode and work at the low speed.
" " OSC KEY
After the fan starts, repeatedly touch this button to start or stop oscillation.
" " PRO KEY
Under power-on state, timed power-off can be set. Press the PRO button; it starts the
timing power-off state. "Timing" and icon displayed on the fan display will flash once
per second, the rotate the drive plate clockwise, the fan display will display 0.5 → 1.0
→ ...... → 12.0 → 00 → 0.5 → ...... in cycle, rotate the drive plate counter-
clockwise, it cycles as 7.5 → ...... → 0.5 → 00 → 12.0 → .......
"will be on. Press this key again, the fan will switch
16