Heidolph Hei-PLATE Mix'n'Heat Expert Betriebsanleitung Seite 125

Appendix
Device control
Command Response
START_1\r\n START_1\r\n
START_2\r\n START_2\r\n
STOP_1\r\n STOP_1\r\n
STOP_2\r\n STOP_2\r\n
RESET\r\n RESET\r\n
PA_NEW\r\n PA_NEW\r\n
PA_OLD\r\n PA_OLD\r\n
CC_ON\r\n CC_ON\r\n
CC_OFF\r\n CC_OFF\r\n
RS-232 interface parameters
➜
➜
➜
➜
IN commands
➜
➜
➜
➜
➜
Command termination
➜
Description
Start heating
Start rotation
Switch off heating
Switch off rotation
Reset all
Switch over to enhanced interface protocol
Switch over to old interface protocol
Connection test on
Connection test off
9600 Baud
Parity: even
Data: 7 Bit
Stop: 1 Bit
X = numerical value with one place after the decimal
Y = Decimal number
Z = multiple numerical values, separated by semicolon
S = ASCII string
If no external temperature sensor is connected, all relevant actual
999.9
values are sent in
...\r\n
format.
125