Troubleshooting - Silvercrest SEM 1100 D3 Bedienungsanleitung

Troubleshooting

Malfunction
The espresso no longer
flows out .
The espresso drips over
the edges of the sieve
holder i, not from the
openings .
The espresso is cold .
The pump is unusually
noisy .
The crema is too light
(the espresso runs out
of the sieve holder i
quickly) .
The crema is too dark
(the espresso runs out
of the sieve carrier i
slowly) .
■ 20 │ GB │ IE │ NI │ CY
Cause
• The espresso powder is too
moist and/or compressed
too tightly .
• No water in the water tank 9 .
• The holes of the sieve holder
openings are blocked .
• The sieve holder i is not
correctly inserted .
• The sieve holder openings are
blocked .
• There are espresso powder
residues on the edges of the
sieve holder i .
• The appliance was not
preheated .
• The "Espresso" control
lamp t has not yet lit up
continuously .
• The cups were not pre-warmed . • Pre-warm the cups .
• The water tank 9 is empty .
• Not enough espresso powder .
• The espresso powder is too
coarsely ground .
• Too much espresso powder .
• The powder is too finely ground
or moist .
• The sieve o p is blocked .
Solution
• Re-prepare the espresso
without compressing the
powder as firmly; if neces-
sary, use new powder .
• Fill the water tank 9
with water .
• Clean the sieve holder i .
• Insert the sieve holder i
correctly .
• Clean the sieve holder i .
• Clean the espresso powder
residues from the edges of
the sieve holder i .
• Preheat the appliance .
• Wait until the "Espresso"
control lamp t lights up
continuously .
• Fill the water tank 9
with water .
• Use more espresso
powder .
• Use only espresso
powder specially manu-
factured for espresso .
• Use less espresso powder .
• Use only espresso
powder specially manu-
factured for espresso .
• Clean the sieve o p .
SEM 1100 D3