Installing The Booster Seat With Backrest Without The Isofix Anchors; Installing The Booster Seat With Backrest With The Isofix Anchors - JANE CONCORD iTOURER Bedienungsanleitung

_ Installing the booster seat with backrest without the ISOFIX anchors

If you decide to install the iTOURER booster seat with backrest without the ISOFIX anchors,
simply place the booster seat on the vehicle seat and pass the seat belt through the bet
guides on the sides of the seat (15) and the one on the side of the headrest (16). These
guides are marked green.
WARNING: When the booster seat with backrest is not in use, it still needs to be fastened
with the vehicle 3-point seat belt. In the event of sudden braking or an accident,
an unrestrained booster seat can get flung about and cause injury to other passengers.
In this configuration, without using the ISOfix anchors, the lights on the status indicator
panel will be red. Only in this case, they do not indicate an installation failure.

_ Installing the booster seat with backrest with the ISOFIX anchors

The booster seat with backrest can be fastened with the ISOFIX anchors, which gives the
seat more lateral stability.
To install the booster seat follow the steps below:
• Pull the two ISOFIX anchors (5) out fully by pressing the buttons on each anchor (5a) and
sliding then out. (5a)
• In some vehicles, the ISOFIX anchors are difficult to access or they are hidden between
the foam sections of the vehicle seat. With the seat we have provided some guides (19)
making it easier to locate them, insert them before the following step.
EN
44