AEG IKE74441IB Benutzerinformation Seite 99

Problem
An acoustic signal sounds and
the hob deactivates.
An acoustic signal sounds when
the hob is deactivated.
The hob deactivates.
Residual heat indicator does not
come on.
Hob²Hood does not work.
Automatic Heat Up does not op‐
erate.
The heat setting changes be‐
tween two levels.
The sensor fields become hot.
There is no sound when you
touch the panel sensor fields.
comes on.
comes on.
Possible cause
The fuse is blown.
You do not set the heat setting for
10 seconds.
You touched 2 or more sensor fields
at the same time.
Pause operates.
There is water or fat stains on the
control panel.
You put something on one or more
sensor fields.
You put something on the sensor
field .
The zone is not hot because it oper‐
ated only for a short time or the sen‐
sor is damaged.
You covered the control panel.
You use a very tall pot which blocks
the signal.
The zone is hot.
The highest heat setting is set.
Power management operates.
The cookware is too large or you put
it too near to the controls.
The sounds are deactivated.
Child Safety Device or Lock oper‐
ates.
There is no cookware on the zone.
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the zone.
Remedy
Make sure that the fuse is the cause of
the malfunction. If the fuse is blown
again and again, contact a qualified
electrician.
Activate the hob again and set the
heat setting in less than 10 seconds.
Touch only one sensor field.
Refer to "Daily use".
Clean the control panel.
Remove the object from the sensor
fields.
Remove the object from the sensor
field.
If the zone operated sufficiently long to
be hot, speak to an Authorised Service
Centre.
Remove the object from the control
panel.
Use a smaller pot, change the cooking
zone or operate the hood manually.
Let the zone become sufficiently cool.
The highest heat setting has the same
power as the function.
Refer to "Daily use".
Put large cookware on the rear zones,
if possible.
Activate the sounds. Refer to "Daily
use".
Refer to "Daily use".
Put cookware on the zone.
Use suitable cookware. Refer to "Hints
and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".
ENGLISH 99