Inhaltsverzeichnis
Werbung
8.14
Funktionsgruppe P13: Optimierung PM-Motor
Funktions-
Funktion
nummer
Reduction rate of the injection
P13.00
current of synchronous motor
Initial pole detection mode
P13.01
Pull-in current 1
P13.02
Pull-in current 2
P13.03
Switch-over frequency of pull-
P13.04
in current
P13.05
High-frequency superposition
frequency
High-frequency superposition
P13.06
voltage
Control parameter 1
P13.08
P13.09
Control parameter 2
Maladjustment detection time
P13.11
High-frequency compensation
P13.12
coefficient od synchronous
motor
High-frequency injection
P13.13
current
*n=nicht einstellbar im Betrieb / j=einstellbar im Betrieb / A=Anzeigefunktion
Grund-
Einstellbereich / Bemerkung
wert
80,0%
0,0...100,0% Motornennstrom
0
0: Keine Erkennung
1: High frequency current injection
2: Pulse superimposition
20,0%
0,0...100,0% Motornennstrom
Pull-in
current
orientation current. Pull-in current 1 is valid
within the lower limit of pull-in current
switch-over frequency threshold. If users
need to increase the starting torque,
increase the value of this function code
properly.
20,0%
0,0...100,0% Motornennstrom
Pull-in
current
orientation current. Pull-in current 2 is valid
within the upper limit of pull-in current
switch-over frequency threshold and users
do not need to change pull-in current 2
under common situations.
10,00Hz
0,00...P00.03 [Hz]
500Hz
200...1000Hz
100%
0,0...300,0% Motornennspannung
0
0...0xFFFF
2,00
0...655,35
0,5s
0,0...10,0s
This parameter is used to adjust the
responsiveness of anti-antimaladjustment
function. If the load inertia is large,
increase the value of this parameter
properly, however, the resonsiveness may
slow down accordingly.
0,0%
0,0...100,0%
This parameter is valid when the motor
speed exceeds the rated speed. If motor
oscillation occurred, adjust this parameter
properly.
20%
0,0...300,0% FU-Nennstrom
HITACHI S 1
is
the
pole
position
is
the
pole
position
Seite
*
n
n
j
j
j
n
n
j
j
j
j
j
89
Werbung
Inhaltsverzeichnis
